Ultrasonic cleaning equipment not only cleaning effect is very good, and low-cost, which promotes the universal use of this commodity. To make the cleanup even more effective in practice, here's what to look out for when you clean up.
First, pay attention to the application frequency
The frequency of the ultrasonic cleaning equipment should be kept within the scope of the manufacturer's proposed manual of use and should not be set to a large or small frequency for cleaning, to prevent the time on the ultrasonic cleaning machine caused damage. In addition, the ultrasonic equipment with the higher frequency of ultrasound will reduce the size of bubbles formed in the liquid, which will make the cleaning compressive strength relatively weak. Therefore, the ultrasonic cleaning machine manufacturers proposed choosing a medium-level frequency cleaning is good.
2. Pay attention to the operating hours
The operating hours of the ultrasonic cleaning equipment are to pay attention to the appropriate operation, generally speaking, the ultrasonic cleaning equipment should not continue to operate for several hours. The long operating time of the machine equipment is likely to lead to the internal machine roller surface and its network hole wall damage. In addition, pay attention to the ultrasonic cleaning machine after the completion of the operation, which should be adjusted to the zero button. In addition, customers are advised to use ultrasonic cleaning equipment before the difficult-to-clean parts after the preparation of the processing system software solution, and then put into the ultrasonic equipment cleaning appropriately, as a result, the operating time of machinery and equipment is greatly reduced.
3. Pay attention to the commodities that are inspected and cleaned
Ultrasonic cleaning equipment cleaning is not the essence of vibration to clean up the goal, vibration is only a by-product of the Ultrasonic transducer in the work. Ultrasonic cleaning on the higher mass density of the cleaned objects can cause the actual effect of resonance, so if there is no defect in the object, the general micro-vibration is not likely to cause a bad effect.
1. The continuous working time of the ultrasonic cleaning equipment shall not exceed 4 hours
If the continuous working time is too long: turn the ultrasonic adjusting knob to the“O” position, let the cooling fan continue to work, and continue to cool in the ultrasonic control cabinet for at least 2 minutes during the ultrasonic cleaning. Not activated. For washing machines that have been running for a long time, turn the power knob to zero before turning it off, then use the fan for 3-6 minutes, and then turn it off again to ensure the heat inside the power supply. Dissipated.
2. Cleaning agents should be timely precipitation, filtration, or replacement to ensure that the cleaning effect
The ultrasonic generator generates a high frequency and high voltage and is transmitted to the transducer through a cable connection. The transducer and the vibrating plate produce a high-frequency resonance. The ultrasonic cleaning machine is mainly composed of an ultrasonic cleaning trough and an ultrasonic generator. Used in ultrasonic cleaning tanks, with an Ultrasonic transducer at the bottom made of high elastic, corrosion-resistant stainless steel, so that the solvent in the tank can be cleaned by Sonication.
Please adjust the power knob manually. Make sure the power knob is in a small place. After the power supply is connected, so as not dip the cleaning solution into the potentiometer. The high-power module of the ultrasonic cleaning machine starts frequently, which will affect the service life of the equipment.
